# Ashok Leyland Ltd Electrical Questions With Answers

Posted on :16-02-2016
Electrical Sample Questions Questions And Answers :

Q1.  For the scalar field u = x2/2 + y2/3 , magnitude of the gradient at the point (1,3) is Options

A) 13/9
B) 9/2
C) 5
D) 9/2

ANS: C

Q2.  A digital-to-analog converter with a full-scale output voltage of 3.5 V has a resolution close to 14m V. Its bit size is Options

A) 4
B) 8
C) 16
D) 32

ANS: B

Q3. A single-phase half-controlled rectifier is driving a separately excited dc motor. The dc motor has a back emf constant of 0.5 V/rpm. The armature . The converter Ωcurrent is 5 A without any ripple. The armature resistance is 2 is working from a 280 V, single phase ac source with a firing angle of 80 degree. Under this operating condition, the speed of the motor will be

Options

A) 339 rpm
B) 359 rpm
C) 366 rpm
D) 386 rpm

ANS: C

Q4. In relation to the synchronous machines, which one of the following statements is false?

A) In salient pole machines, the direct-axis synchronous reactance is greater than the quadrature-axis synchronous reactance
B) The damper bars help the synchronous motor self start
C) Short circuit ratio is the ratio of the field current required to produce the rated voltage on open circuit to the rated armature current
D) The V-curve of a synchronous motor represents the variation in the armature current with field excitation, at a given output power

ANS: C

Q5. The 8085 assembly language instruction that stores the content of H and L registers into the memory locations 2050H and 2051H, respectively, is

A) SPHL 2050H
B) SPHL2051H
C) SHLD 2050H
D) STAX 2050H

ANS: C

Q6. If E  x∇(∇is the electric field intensity,

ANS: Zero

Q7. For the function f(x) = x2 e-x, the maximum occurs when x is equal to

A) 2
B) 1
C) 0
D) -1

ANS: B

Q8. Two wattmeters, which are connected to measure the total power on a three - phase system supplying a balanced load, read 10.5 kW and - 2.5 kW, respectively. The total power  and the power factor, respectively, are Options

A) 13.0 kW, 0.334
B) 13.0 kW, 0.684
C) 8.0 kW, 0.52
D) 8.0 kW, 0.334

ANS: D

Q9. The insulation strength of an EHV transmission line is mainly governed by

B) switching over-voltages
C) harmonics
D) corona

ANS: B

Q10. For the equation, s 3 - 4s2 + s + 6 = 0 the number of roots in the left half of s-plane will be

A) zero
B) one
C) two
D) three

ANS: C

Q11. A dc potentiometer is designed to measure up to about 2 V with a slide wire of 800 mm. A standard cell of emf 1.18 V obtains balance at 600 mm. A test cell is seen to obtain balance at 680 mm. The emf of the test cell is Options

A) 1.00V
B) 1.34V
C) 1.50V
D) 1.70V

ANS: B

Q12. High Voltage DC (HVDC) transmission is mainly used for

A) bulk power transmission over very long distances
B) inter-connecting two systems with the same nominal frequency
C) eliminating reactive power requirement in the operation
D) minimizing harmonics at the converter stations

ANS: A

Q13. A bipolar junction transistor (BJT) is used as a power control switch by biasing it in the cut-off region (OFF state) or in the saturation region (ON state). In the ON state, for the BJT

A) both the base-emitter and base collector junctions are reverse biased
B) the base-emitter junction is reverse biased, and the base-collector junction is forward biased
C) the base-emitter junction is forward biased, and the base-collector junction is reverse biased
D) both the base-emitter and base collector junctions are forward biased

ANS: D

Q14. The Q - meter works on the principle of

A) mutual inductance
B) self inductance
C) series resonance
D) parallel resonance

ANS: C

Q15. A 800 kV transmission line is having per phase line inductance of 1.1 mH/km and per phase line capacitance of 11.68 nF/km. Ignoring the length of the line, its ideal power transfer capability in MW is Options

A) 1204 MW
B) 1504 MW
C) 2085 MW
D) 2606 MW

ANS: C

Q16. If the following program is executed in a microprocessor, the number of instruction cycles it will take from START to HALT is START MVI A, 14H ; Move 14H to register A SHIFT RLC ; Rotate left without carry JNZ SHIFT ; Jump on non-zero to SHIFT HALT

A) 4
B) 8
C) 13
D) 16

ANS: C

Q17. Nm with a μA moving iron ammeter produces a full scale torque of 240  deflection of 120° at a current of 10 A. The rate of change of self inductance H/radian) of the instrument at full scale is μ( H/radian μH/radian

B) 4.8 μ
C) 12.0
D) 114.6μ

ANS: B

Q18. At an industrial sub-station with a 4 MW load, a capacitor of 2 MVAR is installed to maintain the load power factor at 0.97 lagging. If the capacitor goes out of serivce, the load power factor becomes

A) 0.85
B) 1.00
C) 0.80 lag
D) 0.90 lag

ANS: C

Q19. The conduction loss versus device current characteristic of a power MOSFET is best approximated by Options

A) a parabola
B) a straight line
C) a rectangular hyperbola
D) an exponentially decaying function

ANS: A

Q20. If P and Q are two random events, then the following is TRUE

A) Independence of P and Q implies that probability (P)
B) Probability (P Q ) Probability (P) + Probability (Q) Q ) = 0 Options
C) If P and Q are mutually exclusive, then they must be independent
D) Probability (P Q ) Probability (P)

ANS: D

Samsung
Siemens
Bajaj
Maruti
Philips
TVS Motor

Register