ABB Placement Papers
ABB Placement Paper January 2012
ABB Language paper
ABB Placement paper 16 Sep 2013
ABB Verbal Ability Paper
ABB Reasoning Ability Paper
ABB Aptitude Questions
ABB Placement paper on 29th September 2012
ABB Interview Paper
AT & T
Placement Papers for All Companies
Amiti Software Technologies
Ashok Leyland Ltd
AT & T
AXA Technology Services
Bharti Airtel Ltd
Blue Star Infotech
Citicorp Overseas Software Ltd
CtrlS Datacenters Ltd
Ernst & Young
Harita - TVS
HTC Global Services
IBS Software Services
IndiaBulls Power Limited
Jindal Steel and Power Limited
L & T
L & T Infotech
Linde India Ltd
Lucas - TVS
Mahindra Engineering Services Ltd
Poornam Info Vision
PSI Data Systems Limited
SAP labs India
Sutherland Global Services
UTC Aerospace System
ABB Technical Paper
Posted on :11-04-2016
Q1. In a circuit we are giving voltage of 50 Hz as well as 60. then what will be the resultant frequency.
(a) less than 50(b) more than 60(c) in between 50 & 60(d) none
Q2. In a circuit a single resistor is connected across a d.c. source, what will be the effect on current in first resistor if we connect one more resistance in parallel with earlier one....
ANS: no change since it is a parallel combination.
Q3.Why we dont like flashover in transmission line (t-line)- (a ) it may create earth fault(b )it reduces the life of insulator..... Read something about flashover & puncture.
Q4. Total no of strands in a acsr conductor is 81, then what is the no. of conductor in its outer layer
Q5. Two questions based on p.u. calculation like , p.u. calculation is given with respect to some old base and u have to calculate it with reference to new base. (new resistance/old)=(mva new /mva old)*(old voltage/new voltage)2.
Other question is based upon transfer of p.u calculation in transformer i.e. how base changes when we move from primary to secondary or like wise. Read some more on p.u calculation.
Q6. Which table is referred for sag calculation-
Q7. In a R-L circuit a ac voltage is applied, such that instantaneous power is negative for 2ms, then what will be the power factor.
(a) 9 degree(b) 18 degree(c) 36 degree
Q8. In an incandescent lamp
(a) luminous intensity is more than non-luminous intensity
ANS: Since efficiency is less than 100%.
Q9. In which motor no-load to full-load difference is lowest
(a) series motor(b) shunt motor(c) Compound motor
Q10. In a 60Hz induction motor full load speed is 850 rpm then what is the Synchronous speed.
(a) 900 rpm,(b) 950 rpm,(c) 1600 rpm
Q11. A synchronous Motor is running at synchronous Speed, if all of sudden D.C. excitation is removed, then
(a) it will rotate at slip speed,(b) it will stop,(c) it will continue to rotate at synchronous Speed
ANS: because actually it will acts as Induction motor.
Q12. A transmission line is designed for 50Hz, 440KV. If we want to transfer power at 60Hz, 440 KV, then the power transfer capability will
(a) decrease,(b) Increase,(c) None
ANS: (a) ...as P=( |Vt| |Ef| sin (delta) ) / X, where (delta) is torque angle.
Q13. Increased rotor resistance in rotor circuit of induction motor is related with
(a) high starting torque,(b) more speed variation,
Q14. In the formulae E = 4.44 f N Ô, Ô is
(a) Avg value,(b) Rms value,(c) Maximum value.
Q15. Voltage & current in a ckt is given by V= V1+j V2 and I= I1 +j I2, then rms power is
Q16. Input impedence of MOSFET is
Q17. Remember truth table of AND, NOR, NAND, OR, EX-OR ETC...
Q18. Conversion of Binary number into Equivalent decimal No.
Q20. Megger is used for the measurement of
(a) Insulation resistance,(b) Conductor resistance
Q21. Form factor for sinusoidal as well as DC
Q22. Formulae of Regulation (Vs- Vr)* 100/ Vr, then transmission line is
(a) short transmission line,(b) long,(c) medium
Q23. Improvement in power factor reduces
(a) power consumed by consumer,(b) power generation,(c) both a & b
Q24. Read about field test of Series Motor...
Q25. No-load test for Synchronous motor, the graph is drawn
Q26. An AC voltage of 50Hz is impressed in a resistive circuit, the oscillating power has a frequency
(a) 50 Hz(b) 100(c) no oscillating power is there in resistive circuit
Q27. Insulation used in transformer ___________leakage flux.
(a) increases(b) decreases
Q28. After rain what happens to Insulator
(a) break-down strength of Insulator decreases(b)Arch length reduces
Q29. Diversity factor helps to ............(what ?) [Read diversity factor, load factor, Reserve capacity factor in depth, with calculation]
Q30. Why capacitance is shown as a Shunt element in analysis of transmission line
(a) it is between Conductor & earth(b) because Admittance is used for calculation of capacitive reactance
Q31. B-R-Y sequence is followed in three phase system, if phase voltage in B-phase is Vm sin 100, then the phase voltage in R-phase would be
Q32. In a particular ckt I = Im Sin (wt -270) and V = Vm Sin wt, then type of ckt is
(a) pure resistive ckt [Ans]
Q33. In a L-R ckt energy lost = 2000 W, energy conserved = 500W, then what is the time constant...........
ANS: time constant = L/R = 0.5
Q34. In electro - dynamometer Ameter & wattmeter the type of scale is
Q35. For the same current carrying capacity corona loss of ACSR will be ________than copper conductor.
(a) more,(b) less,(c) equal.
Q36. A R-C ckt , supplied with DC, a bulb is connected across the Capacitor, then what happens to the illumination, if we change the capacitance.
ANS: No change at all
Q37. Read about surge impendence of over-head and under-ground cable, Surge impedence formula = sqrt(L/C)
Quatitative Paper + PCM Paper : 45 Questions ---------45 minutes
Q1. About 10 quanti questions ( based on Mixture, Work etc. of very easy type)
Q2. What is GDP ?
Q3. Vector algebra, condition for Co-planer vector etc.
Q4. Gravitation, geo-synchronous satellite( its hight, orbit , radius etc.), escape velocity, how g (gravitational accln) varies, about gravitational potential.
Q5. Basic electricity and Magnetism----Biot-savart law, current carrying conductor properties.
Q6. Nuclear physics, Bohrs constant, and Other theories related .
Q7. Problem based on VIBGYOR , how wave length and frequency is varying.
Q8. Questions based on Planks Theory, E =hv
Q9. V=u + at , V2=u2 + 2as and W = mgh questions based on above theory
Q10. Faradays laws of electrolysis, m = Zit
Q11. Heat conduction problem.
Q12. Colour-coding of resistor (BBROYGBVGW)
Q13. How velocity of light changes in different medium while frequency remain unchanged.
Q14. Statistics , calculation of mode, co-efficient regression (3-4 Questions)
Q15. f(x) = Sin x + Cos x, find the maximum value of the function.......Ans: sqrt (2)
Q16. Formulae for parallel plate capacitor and force between plates.